uniLIGHT ECONOMY.4

The ECONOMY.4 is the little brother of the BLACK.4 control. In some areas it was reduced to the essentials in order to implement simple and inexpensive lighting systems for small and medium-sized models. It is significantly smaller and lighter, but can also only be used for lower outputs and dispenses with protective functions in favor of cost-effectiveness. But here, too, four functions can be controlled:

Channel 1: flashing lights/strobe    The strobes are very bright, white flashing lights. They are usually located at the wingtips or at the end of the fuselage. These are often housed in the same housing as the position lights.
Channel 2: Navigation/position lights   These divide the surrounding space into areas of 120°. GREEN on the right, RED on the left and WHITE to the rear. These lights are usually in continuous operation, sometimes also flashing.
Channel 3: Beacon    The red warning lights are used on the top and bottom of the aircraft, often also on the vertical stabilizer, and indicate “Caution, engine ON”. They are used both as a hard flash light (ACL) and as a rising and falling light (simulated rotating light).
Channel 4: Landing Lights   Always WHITE and facing forward. They are usually installed in the wings, in the engine nacelle or on the chassis.

The Economy.4 does not have its own battery input for the lights. Therefore, small lighting systems can be connected directly to a HV receiver. However, please note the information on the load capacity of the receiver. Alternatively, a separate battery can be connected using the included Y-cable. Despite the small size and focus on economy, the ECONOMY.4 is equipped with some of the functions of the uniLIGHT PLUS family. It can be programmed and configured with the uniLIGHT DESK. The button can only be used to change the flashing pattern in solo mode and the speed of the pattern.

Please note that we cannot accept any guarantee for damaged outputs/amplifiers. Use a BLACK.4 with short-circuit protection to prevent any failures. 

• Control side receiver 4.8-9.6V
• Light signals 4 channels with 2A to 9.6V (3A pulse load)
• Operation also without RC signal
• 15 variable speed effects 
• soft switching programmable
• Navigation with flash function programmable
• uniLIGHT PLUS data mode
• approx. 5g without cable
• Dimension 22x30x6mm
• No short circuit protection & deep discharge protection
• No galvanic isolation
• No reverse polarity protection